You can use Skysset to perform density measurements. The process is slightly different from a regular capture.

  1. First, you must create a new stockpile made from a SINGLE MATERIAL.
  2. Be sure to accurately weigh every load of material collected in the stockpile
  3. Make sure the stockpile is sufficiently separated from other materials so that the will not get mixed.
  4. For best results, make the stockpile as cone shaped as possible. Avoid flat stockpiles.
  5. Make a regular capture of the yard at 40 meter (120 ft) flying height or less
    1. Revuew how a single stockpile capture is performed
    2. If the area covered by the drone during flight is too small, GPS uncertainty becomes an important factor in scale estimation.
    3. Make sure your flight covers an area at least 30 meters by 30 meters, or 90 ft by 90 ft.
    4. If regular yard captures are taken a heights above 40 meters (120 ft), 
  6. Measure the stockpile's volume with Skysset
  7. Divide weight by volume to get density